DRC Moto LED IC Relay for DC
Stock flasher relay is designed to work with standard bulb flashers. When the stock flasher is changed to LED flasher, the stock flasher relay does not work properly because of the difference in power consumption between the stock flasher bulb and the LED flasher. This IC Relay enables LED flashers to work in any configuration.
※Some models need to use this IC relay with the stock IC relay. (RMX250S, DRZ400S/SM etc.)
・Reduced electrical power usage.
・Some skill required for installation.
・One IC relay required for each bike.
・Can not use flasher pilot light and position light when installed XR250.
・If the flasher operates like hazard indicators after installation,
Indicator lamp wiring kit is required(below).
・Works on 12V DC.
♦Important note for using LED flasher
LED flashers have very low consumption and the stock flasher relay may not work properly.
The most frequent problem, is that the LED may be flash at a quick rate using stock flasher relays.
Please refer right side of chart to choose our IC relay or Resistor wire for your installation.
|Parts cost||AC or DC|
|Resistor wire kit||Χ||Ο||Δ||DC/AC|
*DRC IC Relay can not be used with motorcycles (XR50/100M, XLR250, WR250F/WR450F, XR650 etc)due to the AC power design. Please use Resister wire kit for AC power motorcycle.
Check out our Bike Index by Model